Cool Anet A8 Homes Y Pos The Wrong Way References. Anet a8 homes to 0,0, have tried manual home position, disable/enabled z safe homing and nothing, recently change to bowden setup. I have a problem with auto homing.
Final a8 build from www.reddit.com
#define z_min_pos 0 *since your printers was probably shipped with a custom configuration file, it is a best practice to request it from your. X pos.fast, x motor is. So when the printer homes y, the nozzle is in front of the bed, so a negative y value should be used (in front of the bed is the negative y).
Note The (0, 0), The Origin Is The Left Front.
If none of this solves it, it could also be an issue with your linear bearings. If you reduced your bed size, you also might. Hi, i am a newbie trying to make his first print.
If Your Anet A8 Is A Chinesium Clone, The Bearings Are Not What I'd Call Top Notch.
When it happened to me, settings in the slicer program i was using had the. X pos.fast, x motor is. By relocating the switches in the proper position the cube will print in the.
Comments Sorted By Best Top New Controversial.
I had a problem like this. Alter these minimum positions and make sure that the maximum positions (usually just after them) to fit the maximum of the bed. Before exchange, the anet a8:
The Zero Reference For The Axis Of A Anet A8 Are Z Almost Touching The Bed X And Y Front Left Corner.
Anet a8 homes to 0,0, have tried manual home position, disable/enabled z safe homing and nothing, recently change to bowden setup. When i try to home, x axis for example, it goes to the right,. #define z_min_pos 0 *since your printers was probably shipped with a custom configuration file, it is a best practice to request it from your.
I Replaced Mine With Igus Drylin.
I have a problem with auto homing. When executing g29 bed attempted to move to the maximum available position (position y=220), but since the offset was wrong it crashed into the frame. Before going down that road,.
No comments:
Post a Comment